SNMP
Notification Filter
466 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
24
Notification Filter
The Notification Filter page enables configuring SNMP notification filters and Object IDs
(OIDs) that are checked. After creating a notification filter, it is possible to attach it to a
notification recipient in the SNMPv1.2 Notification Recipients page, and SNMPv3
Notification Recipientspage.
The notification filter enables filtering the type of SNMP notifications that are sent to the
management station based on the OID of the notification to be sent.
To define a notification filter:
STEP 1 Click SNMP > Notification Filter.
The Notification Filter page contains notification information for each filter. The table is able
to filter notification entries by Filter Name.
STEP 2 Click Add.
STEP 3 Enter the parameters.
• Filter Name—Enter a name between 0-30 characters.
• Object ID Subtree—Select the node in the MIB tree that is included or excluded in the
selected SNMP filter. The options to select the object are as follows:
- Select from list—Enables you to navigate the MIB tree. Press the Up arrow to go to
the level of the selected node's parent and siblings; press the Down arrow to descend
to the level of the selected node's children. Click nodes in the view to pass from one
node to its sibling. Use the scrollbar to bring siblings in view.
- If Object ID is used, the entered object identifier is included in the view if the
Include in filter option is selected.
STEP 4 Select or deselect Include in filter. If this is selected, the selected MIBs are included in the
filter, otherwise they are excluded.
STEP 5 Click Apply. The SNMP views are defined and the running configuration is updated.
To Next Page
Loading...
Need help?
General
