Status and Statistics
System Summary
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 47
5
System Summary
The System Summary page provides a graphic view of the device, and displays device status,
hardware information, firmware version information, general PoE status, and other items.
To view system information, click Status and Statistics > System Summary.
System Information:
• System Description—A description of the system.
• System Location—Physical location of the device. Click Edit to go the System
Settings page to enter this value.
• System Contact—Name of a contact person. Click Edit to go the System Settings
page to enter this value.
• Host Name—Name of the device. Click Edit to go the System Settings page to enter
this value. By default, the device host name is composed of the word switch
concatenated with the three least significant bytes of the device MAC address (the six
furthest right hexadecimal digits).
• System Object ID—Unique vendor identification of the network management
subsystem contained in the entity (used in SNMP).
• System Uptime—Time that has elapsed since the last reboot.
• Current Time—Current system time.
• Base MAC Address—Device MAC address. If there are several units in the stack, the
base MAC address of the master unit is displayed.
• Jumbo Frames—Jumbo frame support status. This support can be enabled or disabled
by using the Port Settings page.
NOTE Jumbo frames support takes effect only after it is enabled, and after the device is
rebooted.
Software Information:
• Firmware Version (Active Image)—Firmware version number of the active image.
NOTE In a stack, the Firmware Version number shown is based on the version of the
master.
• Firmware MD5 Checksum (Active Image)—MD5 checksum of the active image.
To Next Page
Loading...
Need help?
General
