9-22
Catalyst 2900 Series XL and Catalyst 3500 SeriesXL Software Configuration Guide
78-6511-08
Chapter9 Troubleshooting
Recovery Procedures
Step 7 Enter the switch IP address, and press Return:
Enter IP address: ip_address
Step 8 Enter the subnet mask, and press Return:
Enter IP netmask: ip_netmask
Step 9 Enter Y at the next prompt to specify a default gateway (router):
Would you like to enter a default gateway address? [yes]: y
Step 10 Enter the IP address of the default gateway, and press Return.
IP address of the default gateway: ip_address
Step 11 Enter a host name for the switch, and press Return.
Note On a command switch, the host name is limited to 28 characters; on a member switch to 31
characters. Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter a host name: host_name
Step 12 Enter the password of the failed command switch, and press Return.
Note The password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, allows spaces, but ignores leading spaces.
Enter enable secret: secret_password
Step 13 Enter Y to enter a Telnet password:
Would you like to configure a Telnet password? [yes] y
Note The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but
ignores leading spaces.
Step 14 Enter the Telnet password, and press Return:
Enter Telnet password: telnet_password
Step 15 Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
switch or as a standalone switch.
Note If you enter N, the switch appears as a candidate switch in Cluster Builder. In this case, the
message in Step 20 does not appear.
Would you like to enable as a cluster command switch? y
Step 16 Assign a name to the cluster, and press Return.
Enter cluster name: cls_name
Note The cluster name can be 1 to 31 alphanumeric characters, dashes, or underscores.
To Next Page
Loading...
Need help?
General