4-10
Catalyst 2900 Series XL and Catalyst 3500 SeriesXL Software Configuration Guide
78-6511-08
Chapter 4 General Switch Administration
Default Settings
Flooding Control
Storm control Disabled “Configuring Flooding Controls” section
on page 7-4.
Port > Flooding Control
Flooding unknown unicast
and multicast packets
Enabled “Blocking Flooded Traffic on a Port”
section on page 7-5.
Port > Flooding Control
Cisco Group Management
Protocol (CGMP)
Enabled “Configuring CGMP” section on
page 6-20.
Device > CGMP
Multicast VLAN
Registration (MVR)
Disabled “Configuring MVR” section on page 6-27. –
Internet Group
Management Protocol
(IGMP) filtering
Disabled “Configuring IGMP Filtering” section on
page 6-23.
–
Network Port Disabled “Enabling a Network Port” section on
page 7-6.
–
Network Redundancy
Hot Standby Router
Protocol
2
Disabled “Creating a Cluster Standby Group”
section on page 5-23.
Cluster > Standby Command
Switches
Spanning Tree Protocol Enabled “Configuring STP” section on page 6-33. Device > STP
Unidirectional link
detection (UDLD)
Disabled “Configuring UniDirectional Link
Detection” section on page 7-7.
–
UDLD error detection Enabled “Configuring UniDirectional Link
Detection” section on page 7-7
–
UDLD error recovery Disabled “Configuring UniDirectional Link
Detection” section on page 7-7
–
Port grouping None
assigned
“Creating EtherChannel Port Groups”
section on page 7-7.
Port > EtherChannels
Diagnostics
Displaying statistics,
graphs, and reports
Enabled “Verifying a Switch Cluster” section on
page 5-25.
Reports
Switch Port Analyzer
(SPAN) port monitoring
Disabled “Configuring SPAN” section on page 7-12. Port > SPAN
Console, buffer, and file
logging
Disabled –
Documentation set for Cisco IOS
Release 12.0 on Cisco.com.
–
Remote monitoring
(RMON)
Disabled “SNMP Network Management Platforms”
section on page 4-5.
Documentation set for Cisco IOS
Release 12.0 on Cisco.com.
–
Table 4-2 Default Settings and Where to Change Them (continued)
Feature
Default
Setting Concepts and CLI Procedures CMS Option