A-22
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-08
Appendix A System Messages
Error Message and Recovery Procedures
Error Message LRE_LINK-3-PROFILE_FAILURE: Interface [chars], profile [chars] failure
Explanation When the switch reloads or when the LRE link is lost, the LRE port first attempts to
briefly establish link with the CPE in a common, reduced rate mode. This is so that the switch can
exchange configuration information with the CPE to achieve the link rate of the profile configured
for the port. When the reduced rate is achieved, link is dropped briefly, and the LRE and CPE ports
attempt to establish the profile link rate. If, after a time (typically 30 seconds), no LRE link is
established, this message appears, and the port LED is amber. The port continues to attempt to
establish link, starting from the reduced rate. This message could also mean that the switch or CPE
is faulty.
Recommended Action Change the profile on the port to one that has a lower rate or has a longer reach.
There might be too many impairments on the connection between the switch and the CPE for the
ports to sustain the profile rate. If you suspect the switch or CPE is faulty, contact Cisco Systems.
MAT Messages
This section contains the MAC address table error messages.
Error Message MAT-1-BADFRAME: A bad packet is received on switch port [chars]
Explanation
A packet with either a switch error, a network error, or a wrong port number is received
by the address learning process.
Recommended Action If problems persist, copy the error message exactly as it appears on the console
or in the system log. Enter the show tech-support command to gather data that might provide
information to determine the nature of the error. If you cannot determine the nature of the error from
the error message text or from the show tech-support output, contact your Cisco technical support
representative, and provide the representative with the gathered information.
Error Message MAT-1-NOMEM: Could not allocate memory for [chars] at line [dec] in
[chars]
Explanation System ran out of memory; internal software error.
Recommended Action Copy the error message exactly as it appears on the console or in the system log.
Enter the show tech-support command to gather data that might provide information to determine
the nature of the error. If you cannot determine the nature of the error from the error message text or
from the show tech-support output, contact your Cisco technical support representative, and provide
the representative with the gathered information.
To Next Page
Loading...
Need help?
General