Cisco WS-C2960-24TT-L User Manual

A-4
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-08
Appendix A System Messages
Error Message Traceback Reports
The following is a sample system message:
%LINK-2-BADVCALL: Interface [chars], undefined entry point
Some error messages also indicate the card and slot reporting the error. These error messages begin with
a percent sign (%) and are structured as follows:
Error Message %CARD-SEVERITY-MSG:SLOT %FACILITY-SEVERITY-MNEMONIC: Message-text
where:
• CARD is a code that describes the type of card reporting the error.
• MSG is a mnemonic that means that this is a message. It is always shown as MSG.
• SLOT means that the slot number of the card reporting the error. It is shown as SLOT followed by
a number. (For example, SLOT5.)
Error Message Traceback Reports
Some messages describe internal errors and contain traceback information. This information is very
important and should be included when you report a problem to your technical support representative.
The following sample message includes traceback information:
-Process= "Exec", level= 0, pid= 17
-Traceback= 1A82 1AB4 6378 A072 1054 1860
Error Message and Recovery Procedures
This section lists the switch system messages by facility. Within each facility, the messages are listed by
severity levels 0 to 7: 0 is the highest severity level, and 7 is the lowest severity level. Each message is
followed by an explanation and a recommended action.
[hex] Hexadecimal integer
[inet] Internet address
Table A-3 Representation of Variable Fields in Messages (continued)
Representation Type of Information

Cisco WS-C2960-24TT-L Specifications

General

Model	WS-C2960-24TT-L
Forwarding Rate	6.5 Mpps
RAM	64 MB
Flash Memory	32 MB
Power Device	Internal power supply
Form Factor	Rack-mountable
Weight	3.6 kg
Product Series	Cisco Catalyst 2960
Uplink Ports	2 x 10/100/1000
MAC Address Table Size	8000 entries
Routing Protocol	Static IP routing
Features	VLAN support, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system status
Voltage Required	100-240 VAC
Dimensions (H x W x D)	4.4 cm x 45 cm x 23.6 cm
Operating Temperature	0 to 40 °C
Operating Humidity	10% to 85% non-condensing
Power Consumption	30 W
Ports	24 10/100 Ethernet ports