EasyManuals Logo
Home>Cisco>Switch>WS-C2960-24TT-L

Cisco WS-C2960-24TT-L User Manual

Cisco WS-C2960-24TT-L
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
2-8
Catalyst 2900 Series XL and Catalyst 3500 SeriesXL Software Configuration Guide
78-6511-08
Chapter 2 Getting Started with CMS
Front Panel View
Port Modes and LEDs
The port modes (Table 2-6) determine the type of information displayed through the port LEDs. When
you change port modes, the meanings of the port LED colors (Table 2-7, Table 2-8, and Table 2-9) also
change.
Note The bandwidth utilization mode (UTL LED) does not appear on the front-panel images. Select Reports
> Bandwidth Graphs to display the total bandwidth in use by the switch. Refer to the switch hardware
installation guide for information about using the UTL LED.
To select or change a mode, click the Mode button until the desired mode LED is green.
Table 2-6 Port Modes
Mode LED Description
STAT Ethernet link status of the 10/100, 100BASE-FX, or 1000BASE-X switch ports, or the Ethernet
link status on the remote customer premises equipment (CPE) device.
Default mode on all Catalyst 2900 XL and Catalyst 3500 XL switches except the
Catalyst 2900 LRE XL switches.
LRE
(Catalyst 2900 LRE XL
only)
Long-Reach Ethernet (LRE) link status of the LRE ports on the Catalyst 2900 LRE XL switches.
Default mode on these switches only.
Note When the LRE mode is active, the 10/100 switch ports on the Catalyst 2900 LRE XL
continue to show Ethernet link status.
FDUP or DUPLX Duplex setting on the ports. Default settings are:
• 10/100 ports: Auto
• 100BASE-FX ports: Auto
• Gigabit ports: Auto
• LRE ports: Half-duplex
Note In this mode on the Catalyst 2900 LRE XL switches, the LRE port LEDs show the duplex
mode used on the CPE Ethernet link between the remote CPE and an Ethernet device.
SPEED or SPD Speed setting on the ports. Default setting is auto on the 10/100 ports.
Note In this mode on the Catalyst 2900 LRE XL switches, the LRE port LEDs show the link
speed between the remote CPE and an Ethernet device.
LINE PWR
(Catalyst 3524-PWR XL
only)
Inline power setting on the Catalyst 3524-PWR XL 10/100 ports. Default setting is auto.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C2960-24TT-L and is the answer not in the manual?

Cisco WS-C2960-24TT-L Specifications

General IconGeneral
BrandCisco
ModelWS-C2960-24TT-L
CategorySwitch
LanguageEnglish

Related product manuals