6 - CONTROL
On steady Machine connected to the network and operating properly
Off fan-coil off or disconnected from the power supply; if the fan-coil is off, when the remote control is turned
back on the fan-coil turns on again.
flashes once + pause (Hot or cold) water request not met. This means the fan is stopped until the water temperature reaches a
value that is suitable to meet the request.
flashes twice + pause Communication error. The control involves a continuous exchange of information on the RS485 serial line
with remote control. If this is not provided for more than 5 minutes, the error is displayed and the ventilation
radiator/fan-coil is disabled.
flashes three + pause Blocked as the water is not suitable, unlocked automatically after 45 minutes or manually by pressing the
ON stand-by key twice.
flashes four + pause Water probe malfunction, all the outputs are turned off until the problem is solved.
flashes five+ pause The warning is associated with a fan motor problem (for instance a jam due to foreign bodies, a rotation
sensor failure, activation of the protective micro switch due to the fact that the filter is being cleaned).
Siganal Led
It allows to activate the appliance or to put it in
stand-by (press and hold for 2 sec.)
Reports the appliance is operating. Flashes if
there are any faults.
6.3 ON/OFF KEYPAD WITH WARNING LED
To Next Page
Loading...
Need help?
General
