CLIVET ELFOROOM 3 User Manual

7.1 GENERAL
7 - MAINTENANCE
7.3 CLEANING THE OUTSIDE
7.2 INSPECTIONS FREQUENCY
Routine maintenance is indispensable to keep the cooler-
convector in perfect working condition, safe and reliable over
the years.
This can be done every six months for some interventions and
annually for others, by the Technical Service Assistance,
technically authorised and prepared, using always original
spare parts.
Before every cleaning and maintenance intervention,
disconnect the appliance from the mains by switching off the
master switch.
Wait until the parts have cooled down to avoid the risk of
burns.
When necessary, clean the outer surfaces of the cooler-
convector with a soft cloth damp cloth.
Do not use abrasive sponges or abrasive or corrosive
detergents to avoid damaging the painted surfaces.
• extract the front grill by lifting it slightly ( ref.A) and turn it
until it comes right out of its seat (fig. 7.1 rif. B) ;
• extract the filter ( ref. C), pulling it horizontally outwards
(fig. 7.1 rif. D).
7.4 Extraction of filter cells in the versions with
aspiration
• Insert your hands under the end of mobile panel
• Press the plastic lug B
• Lift and extract the mobile panel C
• Extract the filter D
7.5 Extraction of filter cells in the versions with mobile
aspiration panel
• Suck up the powder with a vacuum cleaner ( rif. A)
• Wash the filter ( ref. B) with running water without using
detergents or solvents, and leave to dry.
• Remount the filter on the cooler-convector (fig. 7.4 ref. A),
taking care to insert the lower flap (fig. 7.4 ref. B) into its
seat (fig. 7.4 ref. C)
• It is forbidden to use the unit without the net filters.
• The appliance is fitted with a safety switch that prevents
the operation of the cooler with the mobile panel missing or
out of position.
• After finishing the cleaning of the filter, check that the panel
is mounted correctly.
7.6 Cleaning filtering seats
fig 7.1
fig 7.2
fig 7.3
The inspections should be carried out at least:
• Every year for only the cooling units
• Every six months for the cooling and warming units
The frequency, however, depends on the use .
In the event of frequent use it is recommended to plan inspec-
tions at close intervals :
• frequent use (continuous or very intermittent use, near the
operating limits, etc)
• critical use (service necessary) .
78

CLIVET ELFOROOM 3 Specifications

General

Brand	CLIVET
Model	ELFOROOM 3
Category	Air Conditioner
Language	English