IGS-NT Communication Guide
5
7.4.2 Values (Oil press, Water temp, Fuel level) – reading 96
7.4.3 Binary input - reading 97
7.4.4 Password decode - reading 97
7.4.5 Gen-set name - reading 98
7.4.6 Engine state - reading 99
7.4.7 Gear teeth – writing 100
7.4.8 Nominal Power – writing 100
7.4.9 Mode – writing 101
7.4.10 Reset/Confirm Alarm 102
7.4.11 Remote Switch 1-8 – Set (Remote Control 1-8) 103
7.4.12 External Value1 – writing 104
7.4.13 User & Password – in two steps 105
7.4.14 User & Password – in one step 106
7.4.15 Start the engine – in one step 106
7.4.16 Start the engine – in two steps 107
7.4.17 History – reading 107
7.4.18 AlarmList reading 109
7.4.19 Change the communication language (only String type data) 110
7.5 Reserved communication objects 111
7.6 Replacing InternetBridge-NT 113
7.6.1 Sites with "NT" family controllers 113
7.6.2 Sites with new controller families 115
7.6.3 Combined sites 117
8 Converters 119
8.1 Converter RS232 ↔ RS485 119
8.1.1 General properties of RS232 to RS485 converters: 119
8.1.2 Recommended converters 120
8.2 RS232 Bluetooth adapter 120
8.2.1 Recommended adapter 120
8.3 Converter USB ↔ RS232 120
8.3.1 Recommended converters 121
8.4 Converter USB ↔ RS485 121
8.4.1 Recommended converter 121
8.5 Converter CAN ↔ CAN 122
8.5.1 Recommended converter 122
8.6 Recommended optical USB extension cables 122
8.6.1 Radio Link 122
8.6.2 Recommended equipment 123
8.7 Converter Modbus RTU ↔ Profibus 123
To Next Page
Loading...
Need help?
General
