To Next Page

To Previous Page

IGS-NT Communication Guide

7.2.6 Gen-set control

SMS command for invoking gen-set control command as Start, Stop, Fault reset etc.

Syntax:

c Y (or cY)

c … command

Y … type of operation

Y Type of operation Y Type of operation

1 Start 7 MCB ON

2 Stop 8 MCB OFF

3 Horn Reset 9 GCB ON/OFF

4 Fault Reset 10 MCB ON/OFF

5 GCB ON 11 Next Mode

6 GCB OFF 12 Previous Mode

Example:

#5:accesscode p 1234, c1

This SMS command invokes gen-set Start. Password setting is needed in case of

password protection was configured for gen-set commands.

Returncode:

ok … gen-set command was accepted

er_pass … valid password was not set before executing the command

c? … unknown gen-set command

c_er … gen-set command execution is not allowed in actual state (e.g. attempt to start the

gen-set in OFF mode).

er_old … command was read out from SMS during GSM modem initialization – in this case

command will not be served.

7.2.7 Read Alarm list

Read actual Alarm list.

Syntax:

a … command

Example:

#5:accesscode a

Request of actual Alarm list.

Returncode:

AL=(items of alarm list) … comma separated items of Alarm list. Exclamation mark in front

of Alarm list item indicates inverse record (still active alarm).

Note:

1. Answer message contains at most eight items of Alarm list.

2. Alarm list is not separated to more messages.

ComAp InteliGen NT Communications Guide

Other manuals for ComAp InteliGen NT