InteliLite Global Guide
451
8.1.2 Values
What values are:
Values (or quantities) are analog or binary data objects, measured or computed by the controller, that are
intended for reading from the controller screen, PC, MODBUS, etc. Values are organized into groups according
to their meaning.
Invalid flag
If valid data is not available for a particular value, the invalid flag is set to it. This situation may be due to the
following:
The value is not being evaluated in the scope of the current application and configuration.
Sensor fail has been detected on an analog input.
The configured ECU or extension module does not provide the particular value.
The communication with the ECU or extension module is interrupted.
A value containing the invalid flag is displayed as “####” in InteliConfig and on the controller screen. If such a
value is read out via MODBUS, it will contain the data 32768 in the case of signed values and 65535 in the case
of unsigned values.
List of values groups
Group: Engine 454
Group: Generator 458
Group: Load 461
Group: Controler I/O 467
Group: Statistics 469
Group: IL Info 473
Group: Log Bout 476
Group: CM-GPRS 478
Group: CM-4G-GPS 483
Group: CM-Ethernet 489
Group: Date/Time 492
Group: Plug-In I/O 492
Group: PLC 493
For full list of setpoints go to the chapter List of values (page 452).
To Next Page
Loading...
Need help?
General
