ComAp InteliLite MRS16 Global Guide

InteliLite Global Guide
87
5.5 Functions
5.5.1 Start-stop sequence 87
5.5.2 Operating Modes 89
5.5.3 Engine start 90
5.5.4 Stabilization 94
5.5.5 Connecting to load 94
5.5.6 MRS operation 94
5.5.7 Dual Operation 95
5.5.8 Engine cool down and stop 97
5.5.9 Alarm management 97
5.5.10 History log 103
5.5.11 Breaker control 104
5.5.12 Exercise timers 107
5.5.13 Rental Timers 114
5.5.14 Service timers 115
5.5.15 Analog switches 115
5.5.16 Additional running engine indications 117
5.5.17 Voltage phase sequence detection 117
5.5.18 Gen-set operation states 118
5.5.19 Sensor curves 120
5.5.20 PLC 122
5.5.21 Geo-fencing 129
5.5.22 Tier 4 Final 129
5.5.23 Alternate configuration 132
5.5.24 ECU Frequency selection 133
5.5.25 Cybernetic security 133
6 back to Controller setup
5.5.1 Start-stop sequence
State Condition of the transition Action Next state
Ready Start request PRESTART (PAGE 585) on Prestart
Time (page 191) counter started
Prestart
RPM > 2 or Oil pressure > Starting
Oil Pressure (page 192) or
Generator voltage > 10V or D+
voltage is higher than D+ Treshold
(page 206)
Stop (Stop
fail)
OFF Mode selected or Shutdown
alarm active
Not Ready
Not Ready RPM < 2, Oil pressure not detected,
Generator voltage < 10V, D+ not
Ready

ComAp InteliLite MRS16 Specifications

General

Brand	ComAp
Model	InteliLite MRS16
Category	Controller
Language	English