13
Regeneration
Operating Instructions OSP and OSG
Proceed as follows:
1. Switch on the CONVOTHERM with the key .
2. Press key
R The last set values or the
default settings for regeneration appear on the
display.
Press key to start immediately.
or
3. Press key
R The cooking chamber
temperature appears on the display. Set the
desired cooking chamber temperature between
120°C and 160°C with the dial or the keys
and .
4. Press key
R Set the desired regeneration
time or continuous operation.
5. Press key
R The cooking programme
‘Regeneration’ starts. The set cooking chamber
temperature and remaining regeneration time
appear on the display.
6. To change the set values during operation, press
keys and correct the values.
7. Read off the actual cooking chamber tempera-
ture and set regeneration time by pressing the
corresponding key once or twice.
8. When the cooking time has expired, the buzzer
sounds and regeneration is terminated. Press
key or open the door.
OSP/OSG
Cooking with the CONVOTHERM
Using this cooking programme you regenerate portioned food served on
plates or platters within a very short time.
Mr.C recommends:
■ Preheating is particularly important during rege-
neration. Only then will you produce optimally
regenerated meals.
■ Further Application examples can be found
in the section "Practical tips".
To Next Page
Loading...
Need help?
General
