Installing the Battery
1. Slide the battery into the opening behind
the digital display with the angled corner on
top. (Figure 103)
5. If there is still no display, contact your
nearest Sears store, or
If the display says:
Battery
ELE
go to step 6.
6. Snap the battery cover into place.
7. Push the ON/OFF button to turn off the dis-
play.
Replacing the Battery
1. Use a screwdriver to pry the battery' cover
off.
Fig. 103- Installingthe Battery
2. Push the battery all the way into this space
and slightly downward. It will snap into place,
and be held there by a tab.
3. If the display says:
ELE
a second or two after the battery is put in
place, go to step 6, or
If the display does not show anything, go to
step 4.
4. Remove the battery. Put it back in and
check the display again, or
Remove the batter),. Wipe off the battery con-
tacts. Put the battery back in and check the
display again, or
Remove the battery. Replace it with a new
one. Check the display again.
2. Push in and slightly upward on the batter),
then pull out. The battery is held in place by a
tab that is released when you push in.
3. Replace the battery with a 6V, alkaline bat-
tery by following the Installing the Battery
section.
Aligning Encoders
Miter Encoder
1. Push the ON/OFF button to turn the dis-
play on.
2. Put the saw in the crosscut position with
the radial arm perpendicular to the fence.
3. Lock the miter lock.
4. Push the MITER button.
5. Push the REF SETbutton. The display will
say:
1
MIT
41
To Next Page
Loading...
Need help?
General