Bevel Encoder
1. Push the ON/OFF button to turn the dis-
play on.
2. Put the saw in the crosscut position with
the radial arm perpendicular to the fence and
the blade perpendicular to the table.
3. Lock the bevel lock.
4. Push the BEVEL button.
5. Push the REF SETbutton. The display will
say:
,
6. Unlock the bevel lock.
7. Turn the motor to the 45 ° bevel position.
CAUTION: The motor is heavy and
can swing down quickly. You can be cut
or injured if the blade hits you. Hold the
motor when you unlock the bevel lock.
14. If the display is correct at all three points,
go to the next section, or
If the display is not correct at one or more of
these points, go to step 15.
15. Unlock the bevel lock.
16. Move the motor to the 45 ° bevel position.
17. Lock the bevel lock.
18. Loosen the two aligning screws on the
bevel encoder until the encoder will slide from
right to left. (Figure 105)
Aligning Screws
Motor Support
Bevel
Encoder
Yoke
Casting
8. Lock the bevel lock.
9. The display should say:
I,
10. Unlock the bevel lock.
11. Move the motor to the 90 ° bevel position.
12. Lock the bevel lock.
13. The display should say:
I °
.v quO
Fig. 105-Screws for Bevel Encoder
19. Slide the encoder slightly until the display
says:
i 4cn ]
You may need to tap on the encoder to move
it, but do not force it or hit it hard.
20. Tighten the two aligning screws on the en-
coder.
21. Repeat steps 2 - 13 to make sure you did
not move the encoder when tightening the
two screws.
To Next Page
Loading...
Need help?
General