Truss Head _*_
Bolt
Fig. 39
6. Attach the four (4) lower stiffeners to the
legs. Two (2) truss head bolts, washers, and
nuts are required to hold each end of a lower
stiffener in place. Hand tighten hex nuts.
7. Go back with a 7/16 wrench or socket and
tighten all hex nuts.
8. Carefully lift the saw into its normal
position. It will be necessary to have someone
help you in order to avoid damaging the saw.
Adjusting Leveling Feet
_Ib WARNING: Saw blade can roll
forward toward you if the leveling feet are
not correctly adjusted. Workpiece or saw
can move unexpectedly if cabinet rocks.
Fingers, hand, or arm can be cut off from
blade contact. Adjust leveling feet before
using your saw.
1. If the leveling feet raise the front of the saw
slightly higher than the rear, and if the leg set
does not rock, go to step 13, or
If the leveling feet do not raise the front of the
saw slightly higher than the rear, go to step 8,
or
If the leg set rocks, go to step 8.
2. Loosen the bottom hex nut on the desired
leveling foot using a 9/16 inch wrench.
3. Loosen the top nut by hand.
4. Adjust the lower nut with the 9/16 inch
wrench until the leveling foot is at the desired
height.
5. Tighten the top nut by hand.
6. Repeat steps 8-11for the other three
leveling feet if necessary.
7. Tighten all four bottom nuts using a 9/16
inch wrench.
Attaching Trim Caps
BOTH MODELS
1. Find the left and right trim caps.
2. There are two plastic stubs on the back of
each trim cap.
3. These stubs will snap into matching holes
at the front corners of the saw.
4. Snap the left and right trim caps into place.
19
To Next Page
Loading...
Need help?
General