D-Link DIR-400 User Manual

70D-Link DIR-400 User Manual
Section 4 - Security
Configuring WPA-PSK and WPA2-PSK
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Wireless Setup on the left side.
2. Next to Security Mode, select Enable WPA Only Wireless
Security (enhanced) or Enable WPA2 Only Wireless Security
(enhanced).
3. Next to Cipher Mode, select TKIP, AES, or Both.
4. Next to PSK/EAP, select PSK.
5. Next to Network Key, enter a key (passphrase). The key is an
alpha-numeric password between 8 and 63 characters long. between 8 and 63 characters long.
The password can include symbols (!?*&_) and spaces. Make
sure you enter this key exactly the same on all other wireless
clients.
6. Click Save Settings to save your settings. If you are conguring
the router with a wireless adapter, you will lose connectivity until
you enable WPA-PSK or WPA2-PSK on your adapter and enter
the same passphrase as you did on the router.

D-Link DIR-400 Specifications

General

Brand	D-Link
Model	DIR-400
Category	Wireless Router
Language	English