DSL-2520U ADSL2/2+ Router with USB and Ethernet Ports
User Manual
Installation and Connection
Connecting to PC
PC with Ethernet Adapter
1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between the Ethernet port located on the back panel of the router
and the Ethernet port of your PC.
3. Connect a phone cable between the DSL port of the router and the ADSL OUT port of the
splitter. Connect your phone to the PHONE port of the splitter. Then connect another phone
cable between a phone jack and the ADSL IN port of the splitter.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Turn on your PC and wait until your operating system is completely loaded.
PC with USB Port
!
Do not connect your router to your PC until the USB driver is installed.
1. Turn on your computer and wait until the operating system is completely loaded.
2. Download the Setup.exe file from D-Link website (ftp.dlink.ru/pub/ADSL/DSL-
2520U/Drivers/) and run it. Wait until the USB driver installation is completed and click the
Finish button.
3. Connect a phone cable between the DSL port of the router and the ADSL OUT port of the
splitter. Connect your phone to the PHONE port of the splitter. Then connect another phone
cable between a phone jack and the ADSL IN port of the splitter.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the router by pressing the ON/OFF button on its back panel.
6. Connect the USB cable between the USB port located on the back panel of the router and
the USB port of your PC.
Page 13 of 83
To Next Page
Loading...
Need help?
Data Transfer Rates
