D-Link DWR-730 User Manual

70D-Link DWR-730 User Manual
Appendix A - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK.
(Windows
®
Vista
™
users type cmd in the Start Search box.)
Type ipcong and press Enter.
This will display the IP address, subnet mask, and the default
gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some rewall software programs may
block a DHCP request on newly installed adapters.

D-Link DWR-730 Specifications

General

wireless standard	802.11g/b, compatible with 802.11n
Micro USB port	Yes
MicroSD slot	Yes
frequency bands	850/900/1800/1900 MHz
Power Class	4 (850/900 MHz), 1 (1800/1900 MHz)
frequency bands	850/1900/2100 MHz, 900/1900/2100 MHz
Power Class	3 (+24 dBm)
HSUPA Downlink	Up to 21.6 Mbps
HSUPA Uplink	Up to 5.76 Mbps
802.11n mode	Up to 150 Mbps
802.11g mode	6/9/11/12/18/24/36/48/54 Mbps
802.11b mode	1/2/5.5/11 Mbps
WEP	64/128-bit
WPA & WPA2	Yes
Built-in NAT	Yes
Built-in firewall	Yes
Type	Internal 3G and Wi-Fi antenna
Capacity	1500 mAh rechargeable
Indicators	SMS, Signal, Battery, Wi-Fi
Operating Temperature	-10 to 55 ˚C (14 to 131 ˚F)
Operating Humidity	10% to 90% (Non-condensing)
CE	Yes
FCC	Yes

Weight and Dimensions

Dimensions (L x W x H)	90 x 50 x 12 mm