D-Link DWR-730 User Manual

23D-Link DWR-730 User Manual
Section 3 - Conguration
DHCP
DHCP Server
Select None from the drop-down menu if you do not wish
to enable the DHCP Server. Select Server to specify a DHCP
server, and enter the information in the elds below.
Set the starting address of the IP range.
Set the ending address of the IP range.
Set the lease time of the IP addresses issued by the DHCP
server.
Click Apply to save the current conguration.
DNS Server
Select None from the drop-down menus if you do not wish to
specify a rst, second, or third DNS server. Select User Dene
to specify a DNS server, and enter the address of the server in
the eld provided.
Click Apply to save the current conguration.
DHCP Mode:
Start IP:
End IP:
Lease Time:
First/Second/
Third DNS
Server:
The DWR-730 has a built-in DHCP server which can assign IP addresses to connected clients. This section allows you to congure the DHCP
settings.

D-Link DWR-730 Specifications

General

wireless standard	802.11g/b, compatible with 802.11n
Micro USB port	Yes
MicroSD slot	Yes
frequency bands	850/900/1800/1900 MHz
Power Class	4 (850/900 MHz), 1 (1800/1900 MHz)
frequency bands	850/1900/2100 MHz, 900/1900/2100 MHz
Power Class	3 (+24 dBm)
HSUPA Downlink	Up to 21.6 Mbps
HSUPA Uplink	Up to 5.76 Mbps
802.11n mode	Up to 150 Mbps
802.11g mode	6/9/11/12/18/24/36/48/54 Mbps
802.11b mode	1/2/5.5/11 Mbps
WEP	64/128-bit
WPA & WPA2	Yes
Built-in NAT	Yes
Built-in firewall	Yes
Type	Internal 3G and Wi-Fi antenna
Capacity	1500 mAh rechargeable
Indicators	SMS, Signal, Battery, Wi-Fi
Operating Temperature	-10 to 55 ˚C (14 to 131 ˚F)
Operating Humidity	10% to 90% (Non-condensing)
CE	Yes
FCC	Yes

Weight and Dimensions

Dimensions (L x W x H)	90 x 50 x 12 mm