xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
234
port-based - If one of the attached hosts pass the authentication, all hosts on the same port will
be granted access to the network. If the user fails the authorization, this port will keep trying
the next authentication.
host-based - Specify to allow every user to be authenticated individually.
vlanid - (Optional) Specifies the VLAN ID used for this configuration.
<vid_list> - Enter the VLAN ID used for this configuration here.
state - (Optional) Specifies whether the authorization mode will be enabled or disabled.
enable - Specifies that the authorization mode will be enabled.
disable - Specifies that the authorization mode will be disabled.
multi_authen_methods - (Optional) Specify the method for compound authentication.
none - Specify that compound authentication is not enabled.
any - Specify if any of the authentication methods (802.1X, MAC, and JWAC/WAC) pass, then
pass.
dot1x_impb - Dot1x will be verified first, and then IMPB will be verified. Both authentications need
to be passed.
impb_jwac - JWAC will be verified first, and then IMPB will be verified. Both authentications need
to be passed.
impb_wac - WAC will be verified first, and then IMPB will be verified. Both authentications need
to be passed.
mac_impb - MAC will be verified first, and then IMPB will be verified. Both authentications need
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
The following example sets the authentication mode of all ports to host-based:
DGS-3420-28SC:admin#config authentication ports all auth_mode host_based
Command: config authentication ports all auth_mode host_based
Success.
The following example sets the compound authentication method of all ports to “any”:
DGS-3420-28SC:admin#config authentication ports all multi_authen_methods any
Command: config authentication ports all multi_authen_methods any
Success.
To Next Page
Loading...
Need help?
General