D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
840
To delete an RSPAN VLAN entry by VLAN ID “3”:
DGS-3420-28SC:admin#delete rspan vlan vlan_id 3
Command: delete rspan vlan vlan_id 3
Success.
DGS-3420-28SC:admin#
9-5 config rspan vlan
Description
This command is used by the source switch to configure the source setting for the RSPAN VLAN. The
redirect command is used by the intermediate or last switch to configure the output port of the RSPAN
VLAN packets, and makes sure that the RSPAN VLAN packets can egress to the redirect ports. In
addition, the VLAN setting must be correctly configured to make the RSPAN VLAN work correctly.
That is, for the intermediate switch, the redirect port must be a tagged member port of the RSPAN
VLAN. For the last switch, the redirect port must be either a tagged member port or an untagged
member port of the RSPAN VLAN based on the users’ requirements. If untagged membership is
specified, the RSPAN VLAN tag will be removed. The redirect function will only work when RSPAN is
enabled. Multiple RSPAN VLANs can be configured with the redirect setting at the same time.
Format
config rspan vlan [vlan_name <vlan_name> | vlan_id <vlanid 1-4094>] [redirect [add | delete]
ports <portlist> | source {[mirror_group_id <value 1-4> | [add | delete] ports <portlist> [rx | tx |
both]]}]
Parameters
vlan_name - Specify the RSPAN VLAN by VLAN name.
<vlan_name> - Specify the VLAN name.
vlan_id - Specify the RSPAN VLAN by VLAN ID.
<vlanid 1-4094> - Specify the VLAN ID between 1 and 4094.
redirect - Specify output port list for the RSPAN VLAN packets. If the redirect port is a Link
Aggregation port, the Link Aggregation behavior will apply to the RSPAN packets.
add - Specify to add the redirect port.
delete - Specify to delete the redirect port.
ports - Specify the output port list to add to or delete from the RSPAN packets.
<portlist> - Specify a range of ports to be configured.
source - If the ports are not specified by this command, the source of RSPAN will come from the
source specified by the mirror command or the flow-based source specified by an ACL.
mirror_group_id - The mirror group identify that specify which mirror session used for RSPAN
source function. If the mirror group is not specified when configuring the mirror ports, the mirror
group 1 will be the default group.
<value 1-4> - Enter the mirror group ID value here. This value must be between 1 and 4.
add - (Optional) Specify to add source ports.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English