xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
375
DGS-3420-28SC:admin# config dnsr primary nameserver 10.24.22.5
Command: config dnsr primary nameserver 10.24.22.5
Success.
To add the entry “dns1” with IP address 10.24.22.5 to the DNS static table:
DGS-3420-28SC:admin#config dnsr add static dns1 10.24.22.5
Command: config dnsr add static dns1 10.24.22.5
Success.
To delete the entry “dns1” with IP address 10.24.22.5 from the DNS static table:
DGS-3420-28SC:admin#config dnsr delete static dns1 10.24.22.5
Command: config dnsr delete static dns1 10.24.22.5
Success.
27-2 enable dnsr
Description
This command is used to enable DNS relay.
Format
enable dnsr {[cache | static]}
Parameters
cache - Specify to enable the cache lookup for the DNS relay on the switch.
static - Specify to enable the static table lookup for the DNS relay on the switch.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable DNS relay:
To Next Page
Loading...
Need help?
General