5
Note: All voltage checks should be made with a voltmeter having a full scale
range of 250 volts or higher. After service is completed, be sure all
safety grounding circuits are complete, all electrical connections are
secure, and all access panels are in place.
Removal and Installation
1. Disconnect the electrical supply from the dishwasher.
2. Open the dishwasher door.
3. Remove the 6 screws that connect the control panel cover to the
dishwasher door.
4. Close the dishwasher door.
5. Release the door latch and allow the control panel cover to hang
against the dishwasher door.
6. Unscrew the screws and disconnect the wire terminals for replace
PCBs, power switch and handle assembly.
The electronic controller allows the user to select the various cleaning
cycles of the dishwasher. All electrical elements in the dishwasher are
controlled by the electronic controller.
Removal and Installation
1. Electronic controller box local in the left side of dishwasher. So first
time we should take off the left side panel.（ See outside panel）
2. Unscrew 2 screws that fix electronic controller box on left uprights,
and take off the electronic controller box by moving it along arrow.
Electronic controller
To Next Page
Loading...
Need help?
General
