21
7. Remove the clamp from the motor washer arm interconnect hose.
Note: Do not attempt to remove the bolt and locknut that connects the motor mount to the
dishwasher frame.
8. Remove the screw and disconnect the ground wire from the wash pump motor
assembly.
9. Pull the motor mount back far enough to clear the motor tab, work the motor from the
attaching hoses, and remove the motor pump assembly from the dishwasher.
10. Reverse the above procedure to install.
The sump assembly consists of the filter assembly, micro-filter, sump clamping nut,
sump gasket, and sump. The filter assembly prevents large particles from reaching the
micro-filter and the micro- filter prevents small particles from reaching the sump. The filter
assembly rests above the sump and the micro-filter sits above the sump basin. The clamping
nut holds the sump gasket and sump to the bottom of the dishwasher.
The filter assembly, micro-filter, and sump clamping nut are accessed from inside the
dishwasher. The gasket and sump are located under the tub in front of the motor pump
assembly.
Removal and Replacement
1. Disconnect power.
2. Remove the top panel, left side panel, right side panel, baseboard and bottom board
Sump Assembly
clamp
To Next Page
Loading...
Need help?
General
