Daewoo DDW-M1212 User Manual

10
16. Take off the tub insulation over the dishwasher tub.
17. Reverse the above procedure to install.
Removal and Replacement
1. Disconnect power.
2. Remove the Outer Door.
3. Remove the 6 screws that connect the control panel cover to the
dishwasher door. (See electronic controller, step 3)
4. Close the dishwasher door.
5. Release the door latch and allow the control panel cover to hang
against the dishwasher door.
6. Disconnect the wire terminals fro m PCBs.
7. Disconnect the 2 terminal lugs from the Door Switch and Latch
Assembly.
8. Disconnect the 4 terminal lugs from the power switch.
9. Disconnect the 4 terminal lugs from the Dispenser switch.
10. Remove the bolt, nut, and ground wire from the door.
11. Pull the wire harness from the door.
Door Assembly

Daewoo DDW-M1212 Specifications

General

Brand	Daewoo
Model	DDW-M1212
Category	Dishwasher
Language	English