Danfoss Series 45 User Manual

Hydraulic parameters
Inlet pressure
Minimum pressure, continuous = 0.8 bar absolute [6.7 inch Hg vac] (at reduced maximum pump speed)
Minimum pressure, cold start = 0.5 bar absolute [15.1 inch Hg vac]
Pressure compensator valve setting
Setting 100 and 130 cc 147 cc
Minimum 100 bar [1450 psi]
Maximum 310 bar [4495 psi] 260 bar [3770 psi]
Case pressure
Maximum continuous: 0.5 bar [7 psi] Above inlet
Intermittent: 2 bar [29 psi] Cold start
Hydraulic fluid
Refer to Danfoss publication Fluids and Filtration BLN-9887 or 520L0463. For information on
biodegradable fluids refer to Biodegradable Hydraulic Fluids 520L0465. See Fluid and Filter Maintenance
on page 20 for recommended fluid and filter change intervals.
Temperature range
(1)
Intermittent (cold start): - 40° C [- 40° F]
Continuous: 82° C [180° F]
Maximum
(2)
: 104° C [220° F]
(1) Hydraulic fluid viscosity must be maintained within the prescribed limits.
(2) As measured at the hottest point in the system, e.g. drain line.
Fluid viscosity
Viscosity limits
Rating mm2/s (cSt) [SUS]
ν continuous minimum 9 [58]
maximum 110 [500]
ν intermittent minimum 6.4 [47]
maximum (cold start) 1000 [4700]
Filtration
Required cleanliness level: ISO 4406 Class 18/13 or better. Refer to Danfoss publications Fluids and
Filtration BLN-9887 or 520L0463 and Design Guidelines for Selecting and Maintaining the Required
Hydraulic Fluid Cleanliness 520L0465. See Fluid and Filter Maintenance on page 20 for recommended
fluid and filter change intervals.
Service Manual
Series 45 E Frame Open Circuit Pumps
Technical specifications
©
Danfoss | September 2016 AX00000024en-US0401 | 11

Danfoss Series 45 Specifications

General

Brand	Danfoss
Model	Series 45
Category	Water Pump
Language	English