Danfoss VLT 5000 FLUX User Manual

VLT
®
5000 FLUX
Indicates the brake power transmitted to an external
brake resistor. The mean power is calculated on
an ongoing basis for the latest 120 sec.
Brake power/sec., parameter 536:
Indicates the given brake power transmitted
to an external brake resistor. Stated as an
instantaneous value.
Heat sink temperature, parameter 537:
States the given heat sink temperature of the
frequency converter. The cut-out limit is 90 ± 5°C,
while the unit cuts back in at 60 ± 5°C.
Alarm word, parameter 538:
States in Hex format whether there is an alarm
on the frequency converter.See section Warning
word 1, Extended status word and A larm word
for further information.
VLT control word, parameter 539:
Gives the control word sent via the serial communication
port in Hex code to the frequency converter. See
the Design Guide for further information.
Warning word, 1, parameter 540:
States in Hex format whether there is a warning
on the frequency converter. See section Warning
word 1, Extended status word and A larm word
for further information.
Extended status word Hex, parameter 541:
States in Hex format whether there is a warning
on the frequency converter.
See section Warningword1,Extendedstatusword
and Alarm word for further information.
Motor RPM, parameter 557:
The displayed value corresponds to the
actual motor RPM.
Motor RPM x scaling, parameter 558:
The displayed value corresponds to the actual
motor RPM multiplied by a factor (scaling)
set in parameter 008.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.55.A6.02 - VLT is a registered Danfoss trademark
114

Danfoss VLT 5000 FLUX Specifications

General

Brand	Danfoss
Model	VLT 5000 FLUX
Category	DC Drives
Language	English