Danfoss VLT 5000 FLUX User Manual

VLT
®
5000 FLUX
175ZA738.10
DISPLAY MODE
MENU MODE
QUICK MENU MODE
DATA CHANGE MODE
▲
▲
▲
▲
▲
▲
▲
▲
▲
Choice of
parameter
DATA MODE
Choice of
data value
Choice of
group
VAR 2
STATUS
VAR 1.1 VAR 1.2 VAR 1.3
1500 rpm
SPEED
0 KEYB.&DISPLAY
1500 rpm
001 LANGUAGE
ENGLISH
SPEED
001 LANGUAGE
ENGLISH
1500 rpm
SPEED
001 LANGUAGE
ENGLISH
1500 rpm
001 LANGUAGE
ENGLISH
DATA CHANGE MODE
1500 rpm
QUICK MENU 1 OF 13
QUICK MENU 1 OF 13
■ Quick Setup via Quick menu
The Quick Menu is used for set-up of closed
loop applications.
The Quick Setup starts with pressing the [QUICK
MENU] key, which brings out the following
read-out on the display:
Line 3: Parameter number and name
Line 4: Status/value of the first parameter
under Quick Setup
The first time the [Quick Menu] key is pressed after
the unit has been switched on, the read-outs always
startatpos. 1-seetablebelow.
The selection of a Quick Menu parameter is
effected by means of the [+/-] keys. The following
parameters are accessible:
Pos.: No.: Parameter: Unit:
1 001 Language
2 102 Motor output [kW]
3 103 Motor Voltage [V]
4 104 Motor frequency [Hz]
5 105 Motor current [A]
6 106 Motor Speed [rpm]
7 107 Automatic Motor
Adaptation AMA
8 329 Encoder feedback
pulses/rev
[ppm]
9 351 Encoder direction
10 207 Ramp-up time 1 [sec]
11 208 Ramp-down time 1 [sec]
12 205 Max reference [rpm]
13 417 Speed PID
proportional Gain
14 418 Speed PID integral
Time
[ms]
15 221 Torque Limit Motor
mode
[%]
16 222 Torque Limit
Generating mode
[%]
■ Menu mode (Parameter setting)
The Menu mode is started by pressing the [MENU] key,
which produces the following read-out on t
he display:
175ZA739.10
1500 rpm
SETUP
1
0 KEYB.& DISPLAY
SPEED
Line 3 shows the parameter group number and name.
Selection of parameter group is effected by
means of the [<>] keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation & Display
1Load&Motor
2 References & Limits
3 Inputs & Outputs
4 Special functions
5 Serial communication
6 Technical functions
7 Application Options
8 Fieldbus Profile
9 Fieldbus Communication
When the desired parameter group has been
selected, each parameter can be chosen by
means of the [+/-] keys.
MG.55.A6.02 - VLT is a registered Danfoss trademark
48

Danfoss VLT 5000 FLUX Specifications

General

Brand	Danfoss
Model	VLT 5000 FLUX
Category	DC Drives
Language	English