Danfoss VLT 5000 Series Operating Instructions

VLT
®
5000 Series
Index
Pre-heat ....................................................................110
Preset reference,
.........................................................123
Preset references
.........................................................118
Process control, closed loop
..........................................103
Process PID
...............................................................146
Programming of Torque limit and stop
............................... 95
Programming Setup
...................................................... 98
Pulse feedback
...........................................................125
Pulse reference
....................................................125, 134
Pulse start/stop
............................................................ 74
Q
Quick discharge ........................................................... 92
Quick Setup
................................................................ 69
Quick-stop
..........................................................123, 152
R
Ramp type .................................................................116
Ramp-down time
.........................................................116
Ramp-up time
.............................................................116
Read out via the serial communication
..............................155
Reference
................................................................... 97
Reference function
.......................................................117
Reference signal
.........................................................115
Reference.
.................................................................127
Reference/feedback unit
................................................142
References - multi-references
.......................................... 83
References - single references
......................................... 81
Relative reference
........................................................127
Relay
.................................................................134, 134
Relay outputs:
......................................................... 13, 13
Reset
.................................................................123, 139
Resistor brake
.............................................................138
Reversing
............................................................123, 153
RFI switch
................................................................... 63
RS 485
....................................................................... 57
S
status word ...............................................................174
Safety earthing
............................................................. 43
Safety interlock
............................................................125
Safety regulations
...........................................................4
Selection of Setup
........................................................152
Selection of Setup,
.......................................................124
Selection of speed
.......................................................152
serial communication
..................................................... 62
Setting of parameters
.................................................... 76
Setup
......................................................................... 98
Setup change
.............................................................. 74
SFAVM
......................................................................149
single references.
..................................................128, 128
Slow down
................................................................118
Software version
..........................................................161
Speed down
...............................................................124
Speed control, closed loop
............................................103
Speed control, open loop
..............................................103
Speed PID
.................................................................143
Speed up
...................................................................124
Start
..................................................................123, 152
Start anti-clockwise only
...............................................123
Start clockwise only
......................................................123
Stator resistance
..........................................................107
Stop
.........................................................................123
Switching frequency
.....................................................141
Switching pattern
.........................................................148
T
Telegram profile ...........................................................153
Thermistor
..................................................................111
Thermistor.
.................................................................127
Tightening-up torques and screw sizes
............................. 45
Time out
....................................................................128
Torque characteristics
..............................................10, 103
Torque control, open loop
..............................................103
Torque control, speed feedback
......................................103
Torque limit
..........................................................118, 119
Torque limit.
................................................................127
Trip locked
.................................................................168
Trouble-shooting
..........................................................164
Two wire start/stop
........................................................ 74
Two-wire transmitter
...................................................... 74
U
U/f characteristic .........................................................144
Unintended start
.............................................................4
Unit data
....................................................................161
Use of emc-correct cables
.............................................. 61
V
VLT 5000 Series protection: ....................................... 16, 16
VLTorderingnumber,
....................................................161
Vlt output data (u, v, w):
.................................................. 10
VLT type,
...................................................................161
Voltage level
...............................................................149
W
Warning against unintended start........................................ 4
Warning word
.............................................................174
Warnings
............................................................168, 169
Warnings and alarms
....................................................168
MG.51.A9.02 - VLT is a registered Danfoss trademark
189

Danfoss VLT 5000 Series Specifications

General

Brand	Danfoss
Model	VLT 5000 Series
Category	DC Drives
Language	English