Danfoss VLT Midi Drive FC 280 Programming Guide

37-14 Pos. Ctrl. Source
Selects the control source for positioning control.
Option: Function:
[0] * DI
[1] FieldBus
37-15 Pos. Direction Block
Use this parameter to congure whether to block a direction,
and the direction to be blocked.
Option: Function:
[0] * No Blocking
[1] Block Reverse
[2] Block Forward
37-16 Pos. Power Recovery
Congures whether to enable the power recovery function.
Option: Function:
[0] Disable
[1] * Enable
37-17 Pos. Ctrl Fault Behaviour
This parameter determines the behavior of the frequency
converter after a fault is detected.
Option: Function:
[0] * Ramp Down&Brake
[1] Brake Directly
37-18 Pos. Ctrl Fault Reason
READ-ONLY PARAMETER: The current fault reason of the alarm.
POSITION CTRL FAULT is displayed in this parameter.
Option: Function:
[0] * No Fault
[1] Homing Needed
[2] Pos. HW Limit
[3] Neg. HW Limit
[4] Pos. SW Limit
[5] Neg. SW Limit
[7] Brake Wear Limit
[8] Quick Stop
[9] PID Error Too Big
[12] Rev. Operation
[13] Fwd. Operation
[20] Can not nd home position
37-19 Pos. New Index
The currently latched index number.
Range: Function:
0* [0 - 255 ]
Parameter Descriptions
VLT
®
Midi Drive FC 280
112 Danfoss A/S © 12/2015 All rights reserved. MG07C102
44

Danfoss VLT Midi Drive FC 280 Specifications

General

Brand	Danfoss
Model	VLT Midi Drive FC 280
Category	DC Drives
Language	English