1D Symbologies Enter/Exit Programming Mode
Product Reference Guide
155
I 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for I 2 of 5 Length Control on
page 154. Length 1 is the minimum
label length if in Variable Length on page
159 Mode, or the first fixed length if in Fixed Length on page 159 Mode. The
length includes the bar code’s check
and data characters.
The length can be set from 2 to 50 characters in increments of two. See "Set
Length 1" on
page 257 for more detailed programming instructions.
$CI2L1
Select I 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
06 = Length 1 is 6 Characters
To Next Page
Loading...
Need help?
General
