Datalogic QuickScan Lite QW2400 User Manual

RS-232/USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 29
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on
page 236 for more detailed programming instructions.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on
page 237 for more detailed programming instructions.
NOTE
Setting to previously defined chara
cters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
Data Bits
on page 22 has been set as 7 Data Bits.
$CR2AC
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
NOTE
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
Data Bits on page 22
has been set as 7 Data Bits.
$CR2NA
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character

Datalogic QuickScan Lite QW2400 Specifications

General

Brand	Datalogic
Model	QuickScan Lite QW2400
Category	Barcode Reader
Language	English