RS-232 ONLY Interface Enter/Exit Programming Mode
Product Reference Guide
21
RS-232 ONLY Interface
Use the programming bar codes in this chapter if modifications to the standard
RS-232 interface settings are necessary to meet your system’s requirements.
Additional settings which apply to both the RS-232 and USB interfaces are
available in Chapter 5, RS-232/USB-COM Interfaces.
RS-232 Standard Factory Settings
Reference Appendix B, for a listing of standard factory settings.
Baud Rate
Baud rate is the number of bits of data transmitted per second. Set the scan-
ner's baud rate to match the baud rate se
tting of the host device. With an
improper baud rate setting, data may not reach the host correctly.
BAUD RAT E on page 21 PARITY on page 23
DATA BITS on page 22 HANDSHAKING CONTROL on page 24
DATA BITS on page 22
$CR2BA00
Baud Rate = 1200
$CR2BA01
Baud Rate = 2400
$CR2BA02
Baud Rate = 4800
$CR2BA03
Baud Rate = 9600
To Next Page
Loading...
Need help?
General
