Enter/Exit Programming Mode Code 11
174 QuickScan™ Lite QW2400
Code 11 Set Length 2
This feature specifies one of the bar code lengths for Code 11 Length Control
on page 173. Length 2 is the maximum label length if in Variable Length on
page 173 Mode, or the second fixed length if in Fixed Length on
page 173
Mode. Length includes the bar cod
e’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 00 specifies to
ig
nore this length (only one fixed length). See "Set Length 2" on
page 259 for
more detailed programming instructions.
DEFAULT
04 = Length 1 is 4 Characters
$CC1L2
Select Code 11 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
To Next Page
Loading...
Need help?
General
