278 Faxing
Available Fax Settings Options
You can use the following settings options for configuring the fax system:
Option Description
Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Fax Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external telephone rings for
the time specified in Auto Rec TEL/FAX, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the
internal speaker indicating that the call is a telephone call.
Ans Machine/Fax The printer can share a telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are
fax tones. If the phone communication is using serial transmission in your
country (such as Germany, Sweden, Denmark, Austria, Belgium, Italy, France
and Switzerland), this mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a separate
number for faxing with a distinctive ring pattern, configure the fax setup to
monitor for that specific ring pattern.
Auto Rec Fax Sets the interval at which the printer goes into the fax receive mode after receiving an incoming call.
Auto Rec TEL/FAX Sets the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call.
Auto Rec Ans/FAX Sets the interval at which the printer goes into the fax receive mode after the external answering
machine receives an incoming call.
Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission through the internal
speaker until a connection is made.
Ring Tone Volume Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through the
internal speaker when Receive Mode is set to Telephone/Fax.
Line Type Sets the line type.
Tone/Pulse Sets the dialing type.
Resend Delay Specifies the interval between transmission attempts.
Redial Attempts Specifies the number of redial attempts to make when the destination fax number is busy. If you enter
0, the printer will not redial.
Redial Delay Specifies the interval between redial attempts.
Junk Fax Setup Sets whether to reject faxes sent from unwanted numbers by accepting faxes only from the fax
numbers registered in the Phone Book.
Remote Receive Sets whether to receive a fax by pressing a remote receive code on the external telephone.
Remote Rcv Tone Specifies the remote receive code in two digits to start Remote Receive.
Fax Header Sets whether to print the information of sender on the header of faxes.
Fax Header Name Sets the name of sender to be printed on the header of faxes. Up to 30 alphanumeric characters can be
entered.
Fax Number Sets the fax number of the printer to be printed on the header of faxes.
Fax Cover Page Sets whether to attach a cover page to faxes.
DRPD Pattern Sets the DRPD setting from Pattern 1 to Pattern 7. DRPD is a service provided by some telephone
companies.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
