42 | Specifications
www.dell.com | support.dell.com
DC Power Requirements
IEEE Standards
The Z9000 complies with the following IEEE standards:
• 802.3ae 10 Gigabit Ethernet
• 802.3ab 1000Base-T
• 802.1p L2 Prioritization
• 802.1Q VLAN Tagging, Double VLAN Tagging (Q in Q), GVRP
• 802.1s Multiple Spanning Tree Protocol
• 802.1w Rapid Spanning Tree Protocol
• 802.3ad Link Aggregation with LACP
• 802.1D Bridging, STP
• 802.3x Flow Control
• 802.1ac Frame Extension for VLAN Tagging
• 802.1x Port Based Network Access Control
Agency Compliance
The Z9000 is designed to comply with the following safety and agency requirements.
USA Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case users will be required to take
whatever measures necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. Dell Force10 is not responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or modifications in the equipment.
Unauthorized changes or modification could void the user’s authority to operate the equipment.
Parameter Specifications
Nominal input voltage -40 to -60 VDC
Maximum DC power supply input current 16.5 A @ -48 VDC
Maximum system power input 789 W
To Next Page
Loading...
Need help?
General