Appendix 187
System Setup
Overview
Use system setup as follows:
• To change the system configuration information after you add, change, or
remove any hardware in your computer
• To set or change a user-selectable option such as the user password
• To read the current amount of memory or set the type of hard drive
installed
Before you use system setup, it is recommended that you write down the
system setup screen information for future reference.
NOTICE: Unless you are an expert computer user, do not change the settings for
this program. Certain changes can make your computer work incorrectly.
Maximum
vibration:
Operating
5 to 350 Hz at 0.0002 G
2
/Hz
Storage
5 to 500 Hz at 0.001 to 0.01 G
2
/Hz
Maximum shock:
Operating
40 G +/- 5% with pulse duration of 2 msec +/- 10% (equivalent
to 20 in/sec [51 cm/sec])
Storage
105 G +/- 5% with pulse duration of 2 msec +/- 10% (equivalent
to 50 in/sec [127 cm/sec])
Altitude:
Operating
–15.2 to 3048 m (–50 to 10,000 ft)
Storage
–15.2 to 10,668 m (–50 to 35,000 ft)
Airborne
contaminant level
G2 or lower as defined by ISA-S71.04-1985
Environmental (continued)
book.book Page 187 Monday, October 6, 2008 11:28 AM
To Next Page
Loading...
Need help?
General