230 Desktop Computer Parts
reflect these changes in system setup. When you restart your computer,
enter system setup (see "Entering System Setup" on page 79), then go to
the "Drives" section of the system setup and under
Drive 0 through 3
, set
the Drive to the correct configuration.
8
Replace the computer cover (see "Replacing the Computer Cover" on
page 257).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
9
Connect your computer and devices to electrical outlets and turn them on.
.
10
Connect your computer and devices to electrical outlets and turn them on.
Installing a Hard Drive
1
Follow the procedures in "Before You Begin" on page 143.
2
Remove the computer cover (see "Removing the Computer Cover" on
1 securing clips (2) 2 hard drive
1 2
To Next Page
Loading...
Need help?
General