Dell OptiPlex 330 - Recovering From a Single Hard Drive Failure Using the Intel Matrix Storage Manager; Setting Your Computer to RAID-Enabled Mode

98 System Setup
Recovering From a Single Hard Drive Failure Using the Intel Matrix
Storage Manager
NOTE: The following steps can be performed only after the failed hard drive has
been replaced (see the appropriate Drives section for your system).
1 Click the Start button and point to Programs → Intel(R) Matrix Storage
Manager
→ Intel Matrix Storage Console to launch the Intel Storage
Utility.
2 Click the Restore RAID 1 data protection button.
3 Click the Rebuild RAID volume now button.
4 Click the Yes button to start rebuilding the RAID volume to the new hard
drive.
NOTE: You can use your computer while the computer is rebuilding the RAID level
1 volume.
Setting Your Computer to RAID-Enabled Mode
1 Enter system setup (see "Entering System Setup" on page 79).
2 Press the up- and down-arrow keys to highlight Drives , and press
<Enter>.
3 Press the up- and down-arrow keys to highlight SATA Operation , and press
<Enter>.
4 Press the left- and right-arrow keys to highlight RAID On , press <Enter>,
and then press <Esc>.
NOTE: For more information about RAID options, see "System Setup Options" on
page 80.
5 Press the left- and right-arrow keys to highlight Save/Exit , and press
<Enter> to exit system setup and resume the boot process.