EasyManuals Logo
Home>Dell>Desktop>OptiPlex 960

Dell OptiPlex 960 User Manual

Dell OptiPlex 960
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Back to Contents Page
Battery
Dell™Optiplex™960MiniTower/Desktop/SmallFormFactorServiceManual
Replacing the Battery
Replacing the Battery
A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.
The battery may need replacing if an incorrect time or date is displayed during the boot routine along with a message such as:
Time-of-day not set - please run SETUP program
or
Invalid configuration information -
please run SETUP program
or
Strike the F1 key to continue,
F2 to run the setup utility
To determine whether you need to replace the battery, reenter the time and date in system setup and exit the program to save the information. Turn off your
computer and disconnect it from the electrical outlet for a few hours; then reconnect the computer, turn it on, and enter system setup (see the Dell
Technology Guide). If the date and time are not correct in system setup, replace the battery.
You can operate your computer without a battery; however, without a battery, the configuration information is erased if the computer is turned off or
unplugged from the electrical outlet. In this case, you must enter system setup (see the Dell
Technology Guide) and reset the configuration options.
To remove the battery:
1. If you have not already done so, make a copy of your configuration information, found in system setup.
2. Perform the procedure Before Working on Your Computer.
3. Remove the computer cover.
4. Locate the battery socket.
5. Remove the system battery.
a. Support the battery connector by pressing down firmly on the positive side of the connector.
b. While supporting the battery connector, press the battery tab away from the positive side of the connector and pry the battery it up out of the
securing tabs at the negative side of the connector.
CAUTION: Before you begin any of the procedures in this section, read the safety information that shipped with your computer. For additional
safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the
object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by
prying off the socket or by breaking circuit traces on the system board.
NOTICE: To avoid damage to the battery connector, you must firmly support the connector while removing the battery.

Table of Contents

Other manuals for Dell OptiPlex 960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell OptiPlex 960 and is the answer not in the manual?

Dell OptiPlex 960 Specifications

General IconGeneral
Tcase72.4 °C
Bus typeFSB
SteppingE0
Processor cache6 MB
Processor cores2
Processor modelE8400
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E8000 Series
Processor socketLGA 775 (Socket T)
Processor codenameWolfdale
Processing Die size107 mm²
Processor frequency3 GHz
Processor cache typeL2
Processor lithography45 nm
Processor manufacturerIntel
Processor front side bus1333 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
Number of processors installed1
CPU multiplier (bus/core ratio)9
Number of Processing Die Transistors410 M
Internal memory4 GB
Memory clock speed800 MHz
Internal memory typeDDR2-SDRAM
Maximum internal memory16 GB
Memory layout (slots x size)2 x 2 GB
HDD speed7200 RPM
HDD interfaceSATA
Optical drive typeDVD-RW
Total storage capacity250 GB
Networking featuresGigabit Ethernet
Graphics card familyAMD
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Discrete graphics card modelAMD Radeon HD 3470
Maximum graphics card memory- GB
On-board graphics card modelNot available
Discrete graphics card memory256 GB
Operating system installedWindows 7 Professional
Microphone inYes
USB 2.0 ports quantity10
Firewire (IEEE 1394) ports0
Ethernet LAN data rates10, 100, 1000 Mbit/s
Chassis typeSFF
Product colorBlack
Product typePC
Processor codeSLB9J
Processor ARK ID33910
Processor package size37.5 x 37.5 mm
Weight and Dimensions IconWeight and Dimensions
Depth323 mm
Width85 mm
Height289 mm
Weight5900 g

Related product manuals