Replacing the solid-state drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Procedure
1 Align the notch on the solid-state drive with the tab on the solid-state drive slot. Then slide the solid-state drive into the solid-state
drive slot at an angle.
2 Align the screw hole on the solid-state drive with the screw hole on the keyboard bracket.
3 Replace the screw (M2x3) that secures the solid-state drive to the keyboard bracket.
Post-requisites
Replace the base cover.
24
Replacing the solid-state drive 39
To Next Page
Loading...
Need help?
General
