Replacing the power button with ngerprint
reader
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
NOTE: Applicable only for computers that are shipped with ngerprint reader.
Procedure
1 Place the power button with ngerprint reader into the slot on the palm-rest assembly. Then adhere the power button with ngerprint
reader cable connector to the keyboard bracket.
2 Replace the two screws (M2x2.5) that secure the power button with ngerprint reader to the palm-rest assembly.
3 Open the power button with ngerprint reader cable connector latch and connect the power button with ngerprint reader cable to
the power button with ngerprint reader.
4 Adhere the power button with ngerprint reader cable to the fan.
5 Open the system board connector latch and connect the power button with ngerprint reader cable to the system board.
32
54 Replacing the power button with ngerprint reader
To Next Page
Loading...
Need help?
General
