Name: Dell PE R720XD
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Installing A 2.5 Inch Hard-Drive Blank (Back)

NOTE: This procedure applies only to PowerEdge R720xd.

Insert the hard-drive blank into the hard-drive slot until it clicks into place.

Removing A 3.5 Inch Hard-Drive Blank

CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks installed.

1. If installed, remove the front bezel.

2. Grasp the front of the hard-drive blank, press the release button and slide the blank out until it is free of the hard-

drive slot.

Figure 21. Removing and Installing a 3.5 Inch Hard-Drive Blank

1. hard-drive blank

2. release button

Installing A 3.5 Inch Hard-Drive Blank

1. If installed, remove the front bezel.

2. Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.

3. If applicable, install the front bezel.

Removing A Hot-Swap Hard Drive

CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the

documentation supplied with your operating system.

1. From the management software, prepare the hard drive for removal. Wait until the indicators on the hard-drive

carrier signal that the hard drive can be removed safely. For more information, see the documentation for the

storage controller.

Other manuals for Dell PE R720XD

Questions and Answers:

Need help?

Do you have a question about the Dell PE R720XD and is the answer not in the manual?

General