Installing System Components 87
Figure 3-22. Installing and Removing the Diskette Drive Into and From the Drive Carrier
Installing the Diskette Drive Into the Drive Carrier
1
Align the back of the diskette drive with the back of the carrier.
2
Add the shim to the drive.
3
Gently push the drive into the carrier until it pops in securely. See Figure 3-22.
Tape Drive
This section describes how to configure and install an internal SCSI or SATA tape drive.
NOTE: Installing a SCSI tape drive requires an optional SCSI controller card.
Removing and Installing an Internal Tape Drive
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product Information
Guide.
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
1 diskette drive tray 2 shim 3 diskette drive
4 diskette drive release tabs (2)
4
1
3
2
To Next Page
Loading...
Need help?
General