EasyManuals Logo
Home>Dell>Switch>S4820T

Dell S4820T User Manual

Dell S4820T
1178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #426 background imageLoading...
Page #426 background image
This phenomenon occurs where traffic is originating from the switch.
1. Management Applications (Applications that are configured as management applications):
The management port is an egress port for management applications. If the management port is
down or the destination is not reachable through the management port (next hop ARP is not
resolved, and so on), and if the destination is reachable through a data port, then the management
application traffic is sent out through the front-end data port. This fallback mechanism is required.
2. Non-Management Applications (Applications that are not configured as management applications as
defined by this feature):
Non-management application traffic exits out of either front-end data port or management port
based on routing table. If there is a default route on both the management and front-end data port,
the default for the data port is preferred route.
Behavior of Various Applications for Switch-Initiated Traffic
This section describes the different system behaviors that occur when traffic is originating from the
switch:
EIS Behavior: If the destination TCP/UDP port matches a configured management application, a route
lookup is done in the EIS table and the management port gets selected as the egress port. If management
port is down or the route lookup fails, packets are dropped.
EIS Behavior for ICMP: ICMP packets do not have TCP/UDP ports. To do an EIS route lookup for ICMP-
based applications (ping and traceroute) using the source ip option, the management port IP address
should be specified as the source IP address. If management port is down or route lookup fails, packets
are dropped.
Default Behavior: Route lookup is done in the default routing table and appropriate egress port is
selected.
Protocol Behavior when EIS is Enabled Behavior when EIS is Disabled
dns EIS Behavior Default Behavior
ftp EIS Behavior Default Behavior
ntp EIS Behavior Default Behavior
radius EIS Behavior Default Behavior
Sflow-collector Default Behavior
Snmp (SNMP Mib response and
SNMP Traps)
EIS Behavior Default Behavior
ssh EIS Behavior Default Behavior
syslog EIS Behavior Default Behavior
tacacs EIS Behavior Default Behavior
426
Internet Group Management Protocol (IGMP)

Table of Contents

Other manuals for Dell S4820T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S4820T and is the answer not in the manual?

Dell S4820T Specifications

General IconGeneral
BrandDell
ModelS4820T
CategorySwitch
LanguageEnglish

Related product manuals