Dell S4820T User Manual

Reload Type : normal-reload
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
----------------------------------------------------------
0 Management online S4810 S4810 8-3-7-13 64
1 Member online S4810 S4810 8-3-7-13 64
2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
Adding a Configured Unit to an Existing Stack
To add a configured unit to an existing stack, use the following commands.
If a stack unit goes down and is removed from the stack, the logical provisioning configured for that
stack-unit number is saved on the master and standby units. When a new unit is added to the stack, if a
stack group configuration conflict occurs between the new unit and the provisioned stack unit, the
configuration of the new unit takes precedence.
1. Add the configured unit to the top or bottom of the stack.
2. Power on the switch.
3. Attach cables to connect ports on the added switch to one or more existing switches in the stack.
4. Log on to the CLI and enter global configuration mode.
• Login: username
• Password: *****
• Dell> enable
• Dell# configure
5. Configure the ports on the added switch for stacking.
CONFIGURATION mode
stack-unit 0 stack-group group-number
• stack-unit 0: defines the default ID unit-number in the initial configuration of a switch.
• stack-group group-number: configures a port for stacking.
6. Save the stacking configuration on the ports.
EXEC Privilege mode
write memory
7. Reload the switch.
EXEC Privilege mode
reload
Dell Networking OS automatically assigns a number to the new unit and adds it as member switch in
the stack. The new unit synchronizes its running and startup configurations with the stack.
Stacking
967

Dell S4820T Specifications

General

Brand	Dell
Model	S4820T
Category	Switch
Language	English