Delta DVP48ES300T User Manual

DVP-ES3 Series Operation Manual
9-20
_9
Notes
 Enable BOOTP: when the IP address receiving mode is BOOTP (BOOTP is enabled), the IP address is
assigned, and the device sends out BOOTP requests for IP addresses during each power-on.
 Enable DHCP: when the IP address receiving mode is DHCP (DHCP is enabled), the IP address is assigned,
and the device sends out DHCP requests for IP addresses during each power-on.
 Disable DHCP/BOOTP: when BOOTP is disabled, the device does not send out any DHCP/BOOTP requests
for IP addresses during each power-on.
9.4.2.4 Re-enable BOOTP/DHCP
To enable the DHCP or BOOTP function again, use the device software to make the change. Using the DVP-ES3 Series
as an example: from the Start menu, start ISPSoft, then HWCONFIG, and then IP Manager. In IP Manager sets the IP
address to the receiving mode.
Open
HWCONFIG
Set up
parameters
Set up IP
receiving mode
Open
EIP Builder
Download
HWCONFIG
Open
IP Manager
 Steps to set device parameters
1.
Refer to Section 9.4.1.1 for how to start HWCONFIG.
2. Set the parameters: enable the IP address receiving mode to BOOTP/DHCP.
 Double-click HWCONFIG to open the DVP-ES3 Setting Page.

Delta DVP48ES300T Specifications

General

Brand	Delta
Model	DVP48ES300T
Category	Controller
Language	English