58
(3) Using the system call function
NOTES:
• The remote control signals of the buttons pressed while registering the system call signals are emitted, so be careful not to operate the
components accidentally (cover the remote sensors, for example).
• If you exceed the number of signals that can be registered, There will be a changeover to the System Call registration screen.
1
Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
Punch Through
(1) Punch through button
Buttons used in the CD, CDR, MD, TAPE, DVD, DVDR,VDP, VCR1
and VCR2 modes can be assigned to the buttons which are not
normally used in the AMP, ZONE2, ZONE3, TV, DBS and CABLE
modes.
For example, when the CD mode is set to the punch through mode
in the AMP mode, the CD mode’s PLAY, STOP, MANUAL
SEARCH, AUTO SEARCH, PAUSE and DISC SKIP buttons’ signals
are sent in the AMP mode.
(2) Making the punch through setting
1
2
Press the power ON button and the OFF button at the same
time.
3
4
Press the mode button for the component you want to punch
through, then press the ENTER button.
•
The punch through is set and the set returns to the normal
operating mode.
Press the “4” button to select punch through setting.
Press the mode button for the component you want to make
the punch through setting, then press the ENTER button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
